Pow-R-Pak Pre-Spray and Power Powder Rinsifier form a combination
method that is:
SAFE to use. Even using it incorrectly you
cannot mess anything up. No rinsing or neutralizing ever necessary.
SIMPLE to use. This program is readily
duplicatable by any one - at any level of expertise - with just 5 minutes of instruction
for carpet cleaning, 30 minutes for furniture cleaning. You should be able to eliminate
several steps you may have been taking.
PROVOCATIVE. You will get immediate, tangible
results that will surpass most previous efforts. Your effort will decrease, and you
production will increase. Your chemical usage will decrease, and your profits will rise.
Your time frames will be shortened, and your labor costs will go down.
PROFITABLE. With the procedure shared here,
your chemical costs and labor costs will decrease dramatically. You'll experience higher
productivity with a better finished product.
Low pH cleaning is NOT a new concept. I was first exposed to it in
1958, and I know that the concepts had been used for years before then.
When you clean fabrics, your intentions are for complete soil removal.
This is accomplished by chemically releasing the soil load from the fabric, putting the
soil load into a suspension, and flushing the suspended soil load out of the fabric.
With some chemical activity, it may be necessary to then rinse the
fabric to get the last of the residual soil load, and/or to rinse the cleaning agent out
of the fabric.
You are all familiar with the cleaning action, and cycles of
"doing laundry". What we are trying to do in fabric cleaning is duplicate this
action as much as possible.
The following procedure will allow you to "wash and rinse"
carpet fabrics using your bonnet system.
Mix 2 Oz. of Pow-R-Pak Pre-Spray per 1 gallon of Hot water. Use in a
pump up sprayer. This will be sprayed directly on the carpet.
Mix ½ Oz. or less, of Power Powder per 1 gallon of Hot water, and
pour into another pump-up sprayer. This solution will be used both on your bonnet, AND
directly on the carpet.
Begin your cleaning by spraying the Pow-R-Pak solution directly on
the carpet. Spray the Power Powder solution onto your bonnet - wetting it thoroughly.
Clean the carpet with your normal pattern and procedure.
After cleaning, LIGHTLY spray the carpet with the Power Powder
solution, and go back over the carpet with a DRY bonnet.
Do your finishing procedures, and if Fabric Protector is to be
applied, apply it at this point.
The results from this simple cleaning procedure will be readily
apparent. The finished fabric will have a "like new" appearance with any
colorization brightened dramatically.
This procedure, using HARD BALL Chemical Company's Pow-R-Pak and Power
Powder optimizes your efforts multiple times over.
The cleaning, and rinsing parallels to laundry system action is readily
available even though you are using the bonnet method.
