Material Safety Data Sheet

Complies with Hazard Communication Standard 29 CFR 1910.1200

Manufacturer

HARD BALL Chemical Company

     

Phone

(888) 261-3103

708 Pulaski Street

     

Fax

(217) 735-4626

Lincoln, IL 62656

     

Emergency Phone

(888) 261-3103

     

Chemtrec Phone

(800) 424-9300

Date Prepared

June 15, 1996

Revised

April 1, 1999

MSDS Number

801

Section I – Product Identification

Product Name:

Power Powder

Chemical Name:

Mixture based on triphosphoric acid, pentasodium salt

NFPA Hazard Classification:

Health – 1, Flammability – 0, Reactivity – 0

Section II – Hazardous Ingredients/Identity Information

The specific chemical identities of the ingredients are considered to be trade secrets and are withheld in accordance with the provisions of 1910.1200 of Title 29 of the Code of Federal Regulations.

Dust from mixture may cause respiratory tract irritation. Mixture is an eye and skin irritant. Mixture is not considered a carcinogen by IARC or NTP. All components are registered with TSCA. This mixture is reasonably believed not to contain any toxic chemicals in quantities subject to reporting requirements of SARA (1986, Section 313, Title III) and 40 CFR 372.

Recommended Occupational Exposure Limit 10 mg/m3 (8 Hour Time Weighted Average) for nuisance dusts.

 

Section III – Physical/Chemical Characteristics

Initial Melting Point

552°C

     

Specific Gravity (H2O=1)

N/A

Vapor Pressure (mm Hg at 68° F)

N/A

     

Evaporation Rate (Butyl Acetate=1)

N/A

pH (1% Solution)

8.5

     

Vapor Density (Air=1)

N/A

Solubility in Water

100%

Appearance & Odor

White granules with mild citrus odor

Section IV – Fire and Explosion Hazard Data

Flash Point (TCC)

None

Autoignition&

None

Flammability Limits in Air

Lower Explosive Limit: None, Upper Explosive Limit: None

Extinguishing Media

N/A

Special Fire Fighting Procedures

Mixture is not combustible

Unusual Fire and Explosion Hazards

None

Section V – Reactivity Data

Stability

Stable

Conditions to Avoid

None

Incompatibility (Materials to Avoid)

None

Hazardous Decomposition or Byproducts

None

Hazardous Polymerization

Will not occur

Section VI – Health Hazard Data & Primary Routes of Exposure

The contents of this mixture have not been tested whole for safety on animals or humans, individual materials present, pose the following health hazards when tested individually at 100%.

Effects of Overexposure:

Eyes

Irritating

Skin

Local irritation.

Inhalation

Dust may cause respiratory tract irritation.

Ingestion

Swallowing of large quantities may cause gastrointestinal tract irritation, nausea, vomiting and diarrhea.

Emergency and First Aid Procedures:

Eyes

Flush with water for 15 minutes and get medical attention. Remove contact lens if worn.

Skin

Immediately flush skin with soap and plenty of water. Remove contaminated clothing.

Inhalation

Remove to area of fresh air. Get medical attention if effects are persistent.

Ingestion

Seek immediate medical care. Immediately dilute swallowed material by giving large quantities of water and induce vomiting by gagging the victim with a finger placed on the back of the victims tongue. Never give anything by mouth to an unconscious person.

Section VII – Precautions for Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled:

Small

Confine and isolate spill. Sweep, scoop or vacuum up and place in container for disposal.

Large

Confine and isolate spill. Sweep, scoop or vacuum up and place in container for disposal.

Waste Disposal Method:

Small

Check federal, state, and local regulations.

Large

Check federal, state, and local regulations.

Handling & Storing:

Store in cool dry place in sealed containers. Keep out of the reach of children.

Other Precautions:

Do not get in eyes, on skin or on clothing. Remove and wash contaminated clothing before reuse. Do not take internally.

Section VIII – Control Measures

Respiratory Protection

Use only in well-ventilated area. NIOSH approved organic respirator where Threshold Limit Value or Permissible Exposure Limit may be exceeded.

Ventilation

Mechanical (general) ventilation is usually adequate.

Protective Gloves

Nitrile or PVC.

Eye Protection

Safety glasses or chemical goggles.

Other Protective Clothing or Equip

None

Work/Hygienic Practices

Practice good personal hygiene. Wash after handling. Avoid contact with skin and eyes. If there is potential for skin contact, the proper impervious clothing should be worn. Avoid breathing dust. Use with adequate ventilation. Keep container closed.

Section IX – Transportation Data

Proper Shipping Name

Not Regulated

DOT Identification Number

N/A

DOT Hazard Class

N/A

The information and recommendations set forth herein are presented in good faith and believed to be correct and reliable. HARD BALL Chemical Co. makes no representation as to the completeness or accuracy thereof and supplies information upon the condition that the persons receiving same will make their own determination as to its suitability for their purpose prior to use.